Great Furnace Nov 19, 2016

It was an easy installation and it went in with no problems. Didn't have to do any adjustments all the factory setting were good and it went right in and hook up was seamless. I would buy another!

Kiss "keep It Simple Stup**" Sep 13, 2016

OK, first thing to do is to consider the space, (including walls and doors) you are trying to condition. Envision the air flow between where the air will eventually come in and where it will be exhausted once you install the ductwork. Lastly, based on the inlet and exhaust locations, figure out where you want to position the unit you are going to use. Now there are lot's of installation tips an experienced professional can offer you while going through this process, but common sense and a... more

Nice Choice Sep 18, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Good Furnace Oct 15, 2016

First furnace I ever installed, very easy to do. I'm ordering one more for the other side of the house.

Crown Boiler Awr038 - 32k Btu - 83.0% Afue - Hot Water Propane Boiler - Chimney Vent Review Aug 15, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more