Did It (almost) All By Myself Aug 04, 2016

I recently purchased the MXZ-2C20NAHZ along with the 12K and 9K floor mounted indoor units. I also purchased two Mitsubishi line sets, wall brackets, disconnect switch and drain tubing. All items were received with very quick shipping and no issues or delays. I installed all items with the exception of the line sets myself. I mounted the outdoor unit, indoor units, installed a new floor drain in my attic to collect condensation, made a new 220 line with disconnect and ran the 14/4 cables to... more

Surprised Jul 13, 2016

My neighbor just spent $3500.00 having a new furnace put on, which for me was out of the question...I bought your furnace (same size) for $575.00 delivered to my door. I'm 75 years old and had it installed and running in 6 hours complete. And that's for changing electric, gas lines, upper plenum and lower base. The unit is quiet and efficient, I couldn't be more happy saving about $3,000.00. Only time will tell how long it will last but I found no shortcuts on the quality of construction..would... more

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Awesome Unit, Great Service May 18, 2016

A family member installed a 22k BTU Mitsubishi mini split in his 4 car garage (also purchased from ecomfort), i was so impressed with his unit i had to buy one myself. I bought this unit to heat and cool an 500sq ft 2 car, garage with 14' ceiling in NJ. I insulated the garage and self installed. The installation in my open garage took about 8 hours start to finish, its a little involved but not over the top, a gauge vacuum set from HF made getting the unit up and running easy. If you or... more

Love Is Fantech Jul 15, 2016

I used this inline fan to hook up to my vent hood in my kitchen. Even though this product was assembled in America, the motor was made in Germany and you certainly can't go wrong with German technology. I also brought LD10 silencer to attach directly to the fan and placed the silencer between the vent hood and the fan. I also purchased the FC10 clamp to hold the silencer and fan in place. I find the clamp itself was not good enough to hold fan and the silencer. To give me a piece of mind,... more