Superb Engineering May 10, 2016

My Mitsubishi has been up and running for about a month now, its currently heating a 440sq ft finished garage. Its super quiet and the heat is even and well controlled. I installed it myself and had no issues whatsoever ( I've worked in industrial automation and controls for many years ). Very nice unit I like it a lot.

Great Looking And Heating Pannel Sep 12, 2016

Have been replacing slant fin through out the house for years. In the past used Runtal, this time Biasi. Wish that the American houses be build with the Euro panels in the first place - heat delivery, fuel savings, aesthetics, etc. no comparison. Runtal was a bit easier to install, more obvious as to in/out connections. Biasi has much more options and the instructions are not the best. Once figured this out the plumber had no problem to install. When we do another Biasi it will be a piece of... more

Nice Choice Oct 10, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Crown Boiler Awr105 - 87k Btu - 83.7% Afue - Hot Water Propane Boiler - Chimney Vent Review Aug 17, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Warmwire Heated Floor Apr 20, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more