Modine 30,000 Hot Dawg Heater Sep 29, 2016

Easy to install. Works great. Only drawback is not as quiet as expected but acceptable.

Really Nice Heater At A Great Price Aug 15, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Crown Boiler Awr070 - 58k Btu - 83.5% Afue - Hot Water Propane Boiler - Chimney Vent Review Sep 02, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Owner, Custom Made Aug 06, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.

Too Early To Tell Oct 12, 2016

Hooked up the heater in late June, so no way to tell how it will work when the cold weather arrives. Hook up was easy, except the schematic didn't really tell which of the possible 5-6 spots the two line thermostat was to be hooked. Blew a fuse the first time I turned it on, but the second placing of the thermostat lines worked.