A O Smith Tankless Hot Water Heater Dec 22, 2016

Just had this 199,900 btu water heater installed and it works so nice and it looks great too. At 10 gpm. we will never run out of water.

Really Nice Heater At A Great Price Sep 12, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Really Nice Heater At A Great Price Aug 03, 2016

I actually bought 5 Pensotti Wall Panel Radiators, 3 of the 20" x 24" and two of these 20" X 48" units. They are replacing hot water baseboard heaters in a basement apartment. These heaters are stylish, extremely efficient and are priced very nicely. Installation was a snap using the included hardware, HOWEVER, I highly recommend purchasing an extra set of brackets for the 20" x 48" heater due to its weight. I used 3 brackets on each heater for a rock solid... more

Saved A Lot Of Money Oct 23, 2016

AC unit of 8 years died during heat spell and contractors where quoting very high prices to replace. Having some mechanical ability I decided to purchase and install a new unit myself. eComfort guided me through the whole system and the new unit was shipped to Calif. in just a few days. Had new unit installed in two days and had a licensed AC Tech do my start-up. I saved almost $6000 dollars. New project will be a whole house fan system which they also sell.

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more